Huawei SmartAX MA5603T Configuration Manual page 1978

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
2.
NOTE
Step 26 Configure the working mode for the LAN port.
1.
2.
Step 27 Configure parameters for a WAN interface.
1.
2.
Issue 01 (2014-04-30)
Open the Web browser, and enter the IP address of the local maintenance Ethernet port on
the ONT. In the login window, enter the user name (default: telecomadmin) and password
(default: admintelecom) of the administrator. After the password is authenticated, the Web
configuration window is displayed.
The following steps are configured on the ONT through the web page.
Choose LAN > LAN Port Work Mode from the navigation tree. Select the check box next
to LAN1 to set port LAN1 to work in Layer 3 mode.
settings.
Figure 19-8 Parameter settings on the Web page for the LAN port
Click Apply to make the configuration take effect.
Choose WAN > WAN Configuration from the navigation tree.
In the right pane, click New. In the dialog box that is displayed, set the parameters as
follows:
l Select Enable WAN Connection to enable the new WAN connection.
l Set Encapsulation Mode to PPPOE or IPOE according to the IPv6 HSI solution.
l Set Protocol Type to IPv4/IPv6 (dual stack) or IPv6 (DS-Lite).
l Set Mode to Route WAN.
l Set Service List to INTERNET.
l Select Enable VLAN.
l Set VLAN ID to 1001.
l Set 802.1p to 0.
l Set User Name to iadtest@pppoe and Password to iadtest.
l Select the check box next to LAN1 in the Binding options area, indicating that the
WAN port is bound to LAN1.
IPv4 Information
l Set IP Acquisition Mode to PPPoE when PPPoE is adopted for HSI. Set IP
Acquisition Mode to Static or DHCP according to the data plan.
l Select Enable NAT to enable the NAT function.
IPv6 Information
l DHCP-PD is recommended for Prefix Acquisition Mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19 IPv6 Configuration
Figure 19-8 shows the parameter
1953