Huawei SmartAX MA5603T Configuration Manual page 1976

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
Step 16 Create an MVLAN and configure the IGMP version.
Set the IGMP version for the MVLAN to IGMP IPv6 v2.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp ipv6 version v2
This operation will delete all IPv6 programs with source IP addresses in the
current multicast VLAN
Are you sure to change current IGMP IPv6 version? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
Step 17 Configure a program library.
Set the mode for obtaining multicast programs to dynamic.
NOTE
You can set the mode for obtaining multicast programs to dynamic only when the IGMP mode is off.
huawei(config-mvlan1000)#igmp ipv6 mode off
Are you sure to close IGMP IPv6? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
huawei(config-mvlan1000)#igmp ipv6 match mode disable
Command has been executed successfully
(Optional) Set the address range for the dynamic programs. If you need to limit the address range
of dynamic programs, perform this operation. For example, set the address range of dynamic
programs to ff15::-ff15::ffff.
huawei(config-mvlan1000)#igmp ipv6 match group ipv6 ff15:: to-ipv6 ff15::ffff
Step 18 Set the IGMP IPv6 mode.
Select the IGMP IPv6 proxy mode.
huawei(config-mvlan1000)#igmp ipv6 mode proxy
Are you sure to change IGMP IPv6 mode? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
Step 19 Configure the IGMP upstream port.
Set the IGMP upstream port ID to 0/19/0 and working mode to default. Protocol packets are
transmitted to all the IGMP upstream ports in the multicast VLAN.
huawei(config-mvlan1000)#igmp uplink-port 0/19/0
huawei(config-mvlan1000)#btv
huawei(config-btv)#igmp uplink-port-mode default
Are you sure to change the uplink port mode?(y/n)[n]:y
Step 20 Configure multicast users.
Add service ports 1 and 2 as multicast users.
Issue 01 (2014-04-30)
huawei(config)#vlan 1000 smart
huawei(config)#port vlan 1000 0/19 0
Create service flows.
Set the service VLAN to 1000, GEM port ID to 13, and user VLAN to 1000, and use traffic
profile 8.
huawei(config)#service-port 1 vlan 1000 gpon 0/1/0 ont 1 gemport 13 multi-
service
user-vlan 1000 rx-cttr 8 tx-cttr 8
huawei(config)#service-port 2 vlan 1000 gpon 0/1/0 ont 2 gemport 13 multi-
service
user-vlan 1000 rx-cttr 8 tx-cttr 8
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19 IPv6 Configuration
1951