Configuring Olt Qinq Vlans And Service Ports - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config)#interface vlanif 8
huawei(config-if-vlanif8)#ip address 192.168.50.1 24
huawei(config-if-vlanif8)#quit
Step 2 Configure the in-band management VLAN and IP address for the ONU.
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#ont ipconfig 1 1 static ip-address 192.168.50.2 mask
255.255.255.0 gateway
192.168.50.1 vlan 8
huawei(config-if-gpon-0/3)#quit
Step 3 Configure the in-band management service port.
Set the management VLAN to 8, GEM port ID to 11, and user VLAN to 8. The OLT does not
rate limit the in-band management service port. Therefore, directly use the default traffic profile
6.
huawei(config)#service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the connection between the management service ports on the OLT and ONU is
reachable.
l Run the ping ONU ip command on the OLT to verify the connectivity between the OLT and
ONU. If the OLT receives ICMP ECHO-REPLY packets from the ONU, the connection is
reachable.
l When the connection is reachable, you can remote log in to the ONU from the OLT and
configure the ONU.
----End

14.4.3.5 Configuring OLT QinQ VLANs and Service Ports

This topic describes how to configure QinQ VLANs and service ports to enable various packets
received from base stations to be forwarded based on specified policies.
Prerequisites
The MAN equipment (for example, CX600) interconnected with the OLT must support the QinQ
VLAN encapsulation mode and be able to terminate QinQ VLANs.
Context
For details on VLAN planning, see
policies for the Ethernet base station access service are shown in
l
l
l
Issue 01 (2014-04-30)
Synchronization packets (remark 1) of the base station are untagged. A VLAN tag is added
to the packets on the ONU and the OLT transparently transmits the VLAN tag.
Different management packets of the base station carry different user VLANs (for example,
20, 21, ... in the following figure). The user VLANs are translated to CVLAN 1001 on the
ONU and then the OLT adds the outer VLAN 300 to the packets before transmitting them
upstream.
Different voice and data packets of the base station carry different user VLANs (for
example, 30, 31, ... in the following figure). The user VLANs are translated to CVLAN
1002 on the ONU and then the OLT adds the outer VLAN 300 to the packets before
transmitting them upstream.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 FTTM Configuration (Base Station Access)
14.2.2 Principle of VLAN Data Plan. VLAN translation
Figure 14-17.
1438