Huawei SmartAX MA5603T Configuration Manual page 1975

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 12 Apply ONT voice service profiles
After ONT voice service profiles are applied, if parameters in those profiles are changed, those
profiles must be reapplied so that the changed parameters can take effect.
1.
2.
Step 13 (Optional) Configure the H.248 user codec.
Run the mgpstnuser codec command to configure the H.248 user codec. The H.248 user codec
will not be configured independently in this example.
Step 14 Configure the traffic profile for the IPTV service.
huawei(config)#traffic table ip index 8 cir off priority 4 priority-policy
local-setting
Step 15 Configure the VLAN translation policy and service port for the multicast service.
1.
2.
3.
Issue 01 (2014-04-30)
Terminal ID
...//The rest of the response information is omitted.
Apply an interface common profile.
Run the if-h248 attribute command to apply an interface common profile to an H.248
interface or configure the interface customized parameters, or run the ont-if-h248 bat-
apply command to bulk apply the interface common profiles to H.248 interfaces. If you
use these two commands to apply the interface common profiles or configure the interface
customized parameters repeatedly, the last configurations take effect.
In this example, the default interface common profile, namely interface common profile 1
is used.
Apply a POTS port profile.
Run the pstnport electric command to apply a POTS port profile to an H.248 interface or
configure the interface customized parameters, or run the ont-pstnport electric bat-
apply command to bulk apply the POTS port profiles to H.248 interfaces. If you use these
two commands to apply the POTS port profiles or configure the interface customized
parameters repeatedly, the last configurations take effect.
In this example, the default POTS port profile, namely POTS port profile 1 is used.
Configure the mapping relationship between a GEM port and an Ethernet port on the ONT.
If the ONT is connected to the STB through Ethernet port 2, map the service flow of Ethernet
port 2 to GEM port 13 in the ONT line profile.
huawei(config)#ont-lineprofile gpon profile-name ftth
huawei(config-gpon-lineprofile-1)#mapping mode port
huawei(config-gpon-lineprofile-1)#gem mapping 13 1 eth 2
huawei(config-gpon-lineprofile-1)#commit
huawei(config-gpon-lineprofile-1)#quit
Configure the VLAN of the Ethernet port on the ONT.
If the ONT is connected to the STB through Ethernet port 2, add Ethernet port 2 to VLAN
1000.
huawei(config)#ont-srvprofile gpon profile-name ftth
huawei(config-gpon-srvprofile-1)#port vlan eth 2 1000
huawei(config-gpon-srvprofile-1)#multicast-forward untag
huawei(config-gpon-srvprofile-1)#commit
huawei(config-gpon-srvprofile-1)#quit
Create a service VLAN and add an upstream port to it.
Add upstream port 0/19/0 to VLAN 1000.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: A1
19 IPv6 Configuration
1950