Understanding Error Messages - i-SENS CARESENS DUAL Owner's Booklet

Step 4
On pressing the ◀ button, the number
indicating the minute will start blinking.
Press the ▶ button to set the minute.
Step 5
S
Press the button to finish and to go to
'alarm2' mode.
Repeat steps 2 to 4 to set the remaining
time alarms (alarm2–3).
Step 6
S
Press the button for 3 seconds to finish and turn the meter
off.
54 www.i-sens.com

Understanding Error Messages

A used test strip was inserted.
> Repeat the test with a new test strip.
The blood or control solution sample was
applied before the
> Repeat the test with a new test strip and wait
until the
the blood or control solution sample.
The temperature during the test was above or
below the operating range.
> Move to an area where the temperature is
within the operating range for blood glucose
test (5–45˚C) or the operating range for blood
β-ketone test (15–30˚C) and repeat the test
after the meter and test strips have reached a
temperature within the operating range.
The blood sample has abnormally high viscosity
or insufficient volume.
> Repeat the test with a new test strip.
symbol appeared.
symbol appears before applying
www.i-sens.com 55