Table of Contents
Advertisement
2 From the Control Menu select Learn Lamp off.
3 Set the DMX control device to issue lamp off.
4 Press
appear.
5 Select √ to finish.
To test that the procedure has been successful, perform the steps described in
"Performing a lamp off command" on page 15.
Teaching di mmed scene co mmand s
If there is a gap between scheduled shows and the lamps remain on, the LightCorder
can set all fixtures to a specific scene, usually with all fixtures dimmed, until the
next scheduled show starts.
To take advantage of this function you need to "teach" the LightCorder the
"dimmed scene". It is up to you whether or not the fixtures are actually dimmed;
you can program any effect.
The LightCorder will issue these instructions whenever a scheduled show ends,
does not restart, is not followed by another scheduled show, and there is no
associated lamp off command scheduled.
To record the dimmed scene settings:
1 Connect the LightCorder to a DMX control device.
2 From the LightCorder Control Menu select Learn Dimmed.
3 Set the DMX control device to achieve the desired scene.
4 Press
5 Select √ to finish.
Configur ing manual intensity control
The three assignable faders are designed to directly control intensity channels
during playback of a show. This enables you to dim up to three groups of fixtures
during playback of any recorded show, and then allows you to return them all to
16
•
to save the lamp off commands. The message 'DMX values saved' will
•
to save. The message 'DMX values saved' will appear.
Advanced mode
Advertisement
Table of Contents
