Table of Contents
Advertisement
• RS-232 command mode can be used to send instructions from a computer or
computer-based control system (such as the Martin ProScenium) to the
LightCorder. This mode is described in "RS-232 command mode" on page 37.
To change mode:
1 From the
2 Select the appropriate mode.
3 Select
Communicating with a PC
When using the PC-based LightCorder Scheduler this menu is used to activate
communication from the LightCorder
To activate PC communication:
1 Connect the RS-232 cable from to the LightCorder and to a COM port on the
PC.
2 Start the LightCorder Scheduler program on the PC.
3 Configure the appropriate COM port in the Scheduler program.
4 Select
5 A message will appear, both in the Scheduler program and on the LightCorder
when communication is successfully established.
Setti ng t he t ime
To set the time:
1 From the
2 Using the ↑ and ↓ buttons to change the numbers, and the Shift button to
change position, set the time.
3 Press
Options
menu select
Yes
to confirm.
PC Communication
Options menu
•
to save it and finish.
Advanced mode
Change System Mode
from the
Options
select
Set time
.
.
menu on the LightCorder.
19
Advertisement
Table of Contents
