Table of Contents
Advertisement
Warning
If you have a relatively large number of fixtures on the data link
it is not a good idea to have them all strike at once as this may
result in fuses blowing. In this case a safer alternative is to
record a lamp-on show with a delay between the lamp strikes on
different channels.
• Are the last scheduled event in a series will need to have the Do lamp off after
option checked. These events are marked with a black indicator. Ensure that the
LightCorder has learned the lamp off DMX instruction. See "Teaching lamp off
commands" on page 15.
• Complete playing and do not have the Do lamp off after option checked will
result in all fixtures on the data link being dimmed until another event occurs. For
this to successfully occur the LightCorder must first "learn" the correct DMX
settings. See "Teaching dimmed scene commands" on page 16.
• Have the Loop until next event option checked will run continuously until the
next scheduled show which will start immediately at its scheduled time. Note that if
there is no other show in the schedule, or to schedule a lamp off, it may be
necessary for you to record an empty "show" lasting not more than a second or two,
and then schedule this with the Do lamp off after option checked.
11 When the schedule is finished it is downloaded to the LightCorder using the
Communication→Transfer Schedule to LightCorder menu. This will replace
any existing schedule.
12 Disconnect the LightCorder from the PC and start Scheduler mode to run the
schedule. See "Running the Schedule" on page 32.
Scheduling
31
Advertisement
Table of Contents
