Table of Contents
Advertisement
F
-S
AIL
AFE MODE
Fail-safe mode enables the LightCorder to be used as a real-time back-up system if
your DMX controller fails. In this configuration the LightCorder is connected on
the data link and is idle until the DMX signal is not present. If this occurs the
LightCorder will start running its default show (see "Setting the default show" on
page 23) until DMX input form the controller is restored.
Note
If you do not set a default show, the LightCorder will run the
first show on the memory card when active.
S T A R T I N G F A I L - S A F E M O D E
To start Fail-Safe mode:
1 From the
Mode
2 Select Go Fail-Safe.
3 Select
will remain inactive. If there is no DMX signal the LightCorder will become active
and start playing the default show (or the first show on the card if no default
show has been set) in a loop.
E X I T I N G F A I L - S A F E M O D E
To return to Advanced mode, simultaneously press and hold the upper button to the
left, and the two upper buttons to the right of the display.
36
menu in Advanced mode, select
Options
.
to confirm. As long as the LightCorder can detect a DMX signal it
Yes
Fail-Safe mode
7
Change System
Advertisement
Table of Contents
