Table of Contents
Advertisement
Menu Operations
H FLIP MODE
The input signal has been inverted horizontally by a mirror type in H FLIP Display
mode.
Select the menu item CONFIG H FLIP to be set to ON, or enable H FLIP in its
coalesced Function Key in Function Key menu, thus to inverse the images
horizontally.
The display result in the Horizontal FLIP MODE is as shown in Figure 4.1-31:
H FLIP mode does not effect on Waveform/Vector, that is, the Wave Form of the
input signal in H FLIP mode will not be inversed horizontally.
AUTO STANDBY
The Auto Standby mode is used to set the status of the monitor when the Power
button is turned on or off.
ON: set AUTO STANDBY item as ON to enable the auto standby mode. Thus,
when detecting no signal input or signal disappeared, the auto standby will be
activated, and there will be a prompt during the process, as shown in Figure
4.1-32:
Figure 4.1-32 Entering the Auto Standby Mode
When detecting no signal input or signal disappeared, the power indicator will
be lit in flash green for 10 seconds, and showing the standby prompt, after that,
the monitor screen will be turned off, and it will be in auto standby mode, the
POWER indicator is lit in red. Then, if the signal input is restored, the monitor
screen will recover and lit up automatically.
Figure 4.1-31 Horizontal Flip Mode
Going into Standby Mode
48
Advertisement
Table of Contents
