Table of Contents
Advertisement
Menu Operations
PBP(Picture by Picture)
The two pictures generated by two input signals separately are displayed side by side,
and this function helps with white balance adjustment, and determining shooting
angles between two cameras etc.
In PBP mode, the size of the main picture is as large as the slave picture's. The
picture displayed at the left side is called as Main picture, and the left is called as
Slave picture, as shown Figure 4.1-28:
In PBP mode, it displays the waveform/vector window for the whole screen, including
the main signal and the slave signal, but for Audio Meter, it is only for the signal of the
main picture, as shown in Figure 4.1-29.
In case of position collision, the waveform/vector window could only be displayed at
the left bottom or right bottom of the screen, as shown in Figure 4.1-29, and
meantime, the Audio Meter could be display only at the top position (Top left or Top
right) at the screen in case of collision.
Figure 4.1-29 Position of WFM and Audio Meter in PBP Mode
Set Display Mode
The display mode on the screen could be single(SUB IN TYPE is OFF), PBP, PIP, set
as instructed below:
OPERATION
Method 1: Set By menu item
Select the Config SUB IN TYPE item, use ENTER, UP or DOWN key to select
a display mode among OFF, PBP and PIP.
Figure 4.1-28 PBP Mode
46
Advertisement
Table of Contents
