OSEE LCM156-E User Manual page 53

Method 2: Set By function key
Designate PBP function to a function key, then press this function key to switch it
value among OFF, PBP and PIP.
For example, Select the FUNCTION KEY F1 item, and set its value as PBP,
as shown in Figure 4.1-30, then, press F1 to switch the display mode.
 Scope for the signal source of the slave picture
The selection scope of the signal source for the slave picture will be changing in
accordance with the main picture's source, the available formats are as shown in
Table 4.1-9:
Table 4.1-8 The Relationship of the Signal Source for Slave Picture and Main
Signal Source for
Main Picture
SDI1
\ Signal Source for
Slave Picture

SDI1

SDI2

LINE1(CVBS)

LINE2(CVBS)

LINE2(Y/C)

LINE2(YPBPR)

HDMI
 Position for signal source menu: The input signal information of the main
picture displays at the top left corner of the screen, and the one of the slave
picture displays at the top right corner of the screen.
 Settings for signal source: Press INPUT button to set the signal source for
the main picture, and select CONFIGSUB IN TYPE item to set the signal
source for the slave picture.
F1
F2
F3 ANAMORPHIC
F4 FLASE COLOR
F5
Figure 4.1-30 Set the Function Key as PBP
SDI2 LINE1(CVBS) LINE2(CVBS) LINE2(Y/C) LINE2(YPSPR) HDMI
 






 
 
 
FUNCTION
PBP PBP
NATIVE OFF
OFF
FREEZE OFF
Picture
 
 
 
 
 


 
47
Menu Operations
4:3













