Slide Runner Inspection - Yamaha SRX700D Service Manual

4
6
TRACK TENSION ADJUSTMENT/

SLIDE RUNNER INSPECTION

SDN2600
5
SDN2610
7
SDN2620
SDN2630
a. Start the engine and rotate the track once or
twice. Stop the engine.
b. Check the track alignment with the slide run-
ner 3.
If the alignment is incorrect, turn the left and
right adjusters to adjust.
Track alignment
4 Left adjuster
5 Right adjuster
8 9
Slide runner
0 A
Track metal
c. Adjust the track deflection until the specified
amount is obtained.
Track deflection
4 Left adjuster
5 Right adjuster
CAUTION:
The adjusters should be turned an equal amount.
•
Recheck the alignment and deflection. If nec-
essary, repeat steps (a) to (c) until the speci-
fied amount is obtained.
•
Tighten the rear axle nut.
Nut (rear axle):
75 Nm (7.5 m • kg, 54 ft • lb)
SLIDE RUNNER INSPECTION
1. Inspect:
•
Slide runner 1
Cracks/damage/wear → Replace.
2. Measure:
•
Slide runner thickness a
Out of specification → Replace.
Slide runner wear limit:
10 mm (0.39 in)
2-30
INSP
ADJ
6 Shifted 7 Shifted
to right to left
Turn out Turn in
Turn in Turn out
Track
B
Gap Forward
More than Less than
specified
specified
Turn in Turn out
Turn out
Turn in