Track Tension Adjustment - Yamaha SRX700D Service Manual

TRACK TENSION ADJUSTMENT

TRACK TENSION ADJUSTMENT
WARNING
A broken track or track fittings, and debris thrown
by the track could be dangerous to an operator or
bystanders. Observe the following precautions.
•
Do not allow anyone to stand behind the
machine when the engine is running.
•
When the rear of the machine is raised to allow
the track to spin, a suitable stand must be used
to support the rear of the machine. Never allow
anyone to hold the rear of the machine off the
ground to allow the track to spin. Never allow
anyone near a rotating track.
•
Inspect the condition of the track frequently.
Replace the track if it is damaged to a level
where the fabric reinforcement material is
visible.
•
Never install studs (cleats) closer than 76 mm
(3 in) to the edge of the track.
1. Lift the rear of the machine onto a suitable
stand to raise the track off the ground.
2. Measure:
•
Track deflection a
Using a spring scale 1, pull down on the
center of the track with 10 kg (22 lb) of force.
Out of specification → Adjust.
SDN2580
3. Adjust:
•
Track deflection
Adjustment steps:
•
Place the machine onto a suitable stand to
raise the track off of the ground.
•
Loosen the rear axle nut 1.
NOTE:
It is not necessary to remove the cotter pin 2.
SDN2590
2-29
INSP
ADJ
Track deflection a:
25 ~ 30 mm (0.98 ~ 1.18 in)