1
HEADLIGHT BEAM ADJUSTMENT
ELECTRICAL
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine in front of a wall at the
recommended distance D. Refer to the table
below.
SDN2740
3. Measure the distance H from the floor to the
center of the headlight and place a mark on
the wall at that height.
4. With a person sitting on the machine, apply
the parking brake, start the engine and let it
idle.
5. Switch on the headlight's high beam and
check the height of the projected beam on the
wall. The projection should be at the position
marked in step 3 or 1/2° lower (set range S).
D
S
D: Distance
6. Adjust:
•
2
SDN2750
7. Adjust:
•
2-34
INSP
ADJ
3.0 m (10 ft)
26 mm (1.0 in)
S: Set range
Headlight beam (vertically)
Vertical adjustment
Turn the adjusting screw 1 + 2
Higher
clockwise.
Turn the adjusting screw 1 + 2
Lower
counter clockwise.
Headlight beam (horizontally)
Horizontal adjustment
To right Turn the adjusting screw 1
clockwise or turn the adjusting
screw 2 counter clockwise.
To left
Turn the adjusting screw 2
clockwise or turn the adjusting
screw 1 counter clockwise.
7.6 m (25 ft)
66 mm (2.6 in)