Starter (Choke) Cable Freeplay Adjustment; Exhaust System Inspection - Yamaha SRX700D Service Manual

STARTER (CHOKE) CABLE FREEPLAY ADJUSTMENT/

EXHAUST SYSTEM INSPECTION

STARTER (CHOKE) CABLE FREEPLAY
ADJUSTMENT
1. Measure:
•
SDN2240
2. Adjust:
•
Adjustment steps:
•
Loosen the locknut 1.
•
Turn the adjusting nut 2 in or out until the
specified freeplay is obtained.
Turning in → Freeplay is increased.
Turning out → Freeplay is decreased.
•
Tighten the locknut.
EXHAUST SYSTEM INSPECTION
1. Open the shroud.
2. Remove:
•
3. Inspect:
•
•
•
•
•
•
4. Check:
•
SDN2310
5. Install:
•
2-13
INSP
ADJ
Starter cable freeplay a
Out of specification → Adjust.
Starter cable freeplay a:
0.5 ~ 1.5 mm (0.02 ~ 0.06 in)
Starter cable freeplay
Springs
Refer to "EXHAUST ASSEMBLY" in CHAP-
TER 5.
Exhaust joints 1
Exhaust pipes 2
Exhaust silencer 3
Cracks/damage → Replace.
Exhaust gaskets 4
Exhaust gaskets 5
Exhaust gaskets 6
Exhaust gas leaks → Replace.
Tightening torque
Bolt (exhaust silencer joint):
13 Nm (1.3 m • kg, 9.4 ft • lb)
Nut (exhaust silencer):
16 Nm (1.6 m • kg, 11 ft • lb)
Bolt (exhaust pipe joint):
15 Nm (1.5 m • kg, 11 ft • lb)
Springs
Refer to "EXHAUST ASSEMBLY" in CHAP-
TER 5.