HP D300 Operating Manual page 69

Table 6-1 Error message guide
Error message text
Unable to send! Some data are not in the correct
format.
Unable to start dispensing this split. (Already
dispensing.)
Unable to start dispensing this split. (Invalid
Dispensehead number.)
Unable to start dispensing this split. (Lost
comms?)
Unable to start dispensing this split. (Unknown
plate type.)
Error message title
Data Format Error
Dispense Error
Dispense Error
Dispense Error
Dispense Error
HP D300 Digital Dispenser
Recommended action
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser and then restart
the software
Wait until the dispenser is finished
dispensing and retry if necessary.
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser, restart the
software, and retry the configuration.
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser, restart the
software, and retry the configuration
after deleting wells that have already
been dispensed.
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser, restart the
software, and retry the configuration.
69