View The Report - HP D300 Operating Manual

9. After the current set of fluids is dispensed into all appropriate plates, if needed the software will
prompt you to load a new cassette using the message shown in
T8 cassette is removed from the D300 dispenser it may be disposed, as it will not be reused.
10. You will then be shown which fluids to place in each dispensehead of the new cassette as
shown in

4-6 View the report

Depending on the options selected in the Report pane, a report may be automatically generated and
saved on your computer after the plate dispense operation is completed. To change these report
settings, click Setup, then Options, and then Report (see
If you have chosen not to display the report after each run, you can still view data from the most
recently completed run by clicking File and then View Report. See
Figure 4-27 Open the Report dialog box by clicking File and then View Report
If you are not sure if a report was automatically saved, look at the title bar of the Report dialog box
(see Figure 4-28). If a file name is displayed in the title bar, then the report was automatically
saved. Even if you did not choose to automatically save the report, you can still save the current
report by clicking the Save button in the lower-right corner of the Report dialog box.
Figure 4-22, and steps 7 - 9 above will continue until the configuration is complete.
HP D300 Digital Dispenser
Figure 4-20. After a fully used
―Options:
Report‖).
Figure 4-27.
27