Use The Paste Special Dialog Box - HP D300 Operating Manual

Figure 5-7 Array of wells with two fluids per well
5. To easily replicate a plate design, you can select all the wells in a plate you have designed,
then right click and select Copy, then click on Add Plate. Select the A1 well of the new plate,
then right click and select either Paste or Paste Special depending on whether you want to
have the same fluids in both plates. For more information about Paste Special, see
Paste Special dialog

5-5 Use the Paste Special dialog box

Instead of defining titrations separately for each fluid as described above, titrations can be copied
and pasted with new fluids once a starting titration is created. If you would like your plate to contain
the same titration for many different fluids, you can use
use Paste Special. For Paste Special, follow these steps:
1. Program the initial titration, then ensure the wells you want to copy are selected, then right-
click in the well plate image and then click Copy.
2. Click in a new well to select the new starting well for the Paste Special, then right-click, and do
one of the following:
○
To paste the same fluid into new wells, click Paste.
○
To paste a different fluid into new wells, click Paste Special. This opens the Paste Special
dialog box where you can accept the suggested fluid to paste or use the drop-down list box
to select a different new fluid to paste. See
In the example shown below, wells A1 to B12 were copied, and fluid 1 will be mapped to fluid
3 and fluid 2 mapped to fluid 4. The result of this Paste Special operation is shown in
5-9.
Figure 5-8
box‖ below.
Paste Special dialog box
HP D300 Digital Dispenser
―Plate Layout Wizard basics"
Figure 5-8.
―Use the
or you can
Figure
38