Get Started; Start Up The Dispenser - HP D300 Operating Manual

4

Get started

The HP D300 Digital Dispenser runs on standard AC power, either 120V or 230V, depending on the
Dispenser version. HP Product Number CV079A runs on 120V and CV080A runs on 230V. The
Product Number and the voltage requirement is shown on the label on the rear of the Dispenser.
WARNING: Be sure the dispenser matches your outlet voltage. The voltage requirement is shown
on the label on the rear of the dispenser. Do NOT plug the dispenser in to the incorrect voltage.
If the labeled voltage on your dispenser does not match your standard outlet, contact your Tecan
Service Help Desk.
Two electrical outlets are required, one for the dispenser and another for the computer. A dedicated
circuit is not required as the dispenser draws less than two amps.
The dispenser requires a level bench space which is 50 cm (19 inches) wide, 46 cm (18 inches)
deep, and 26 cm (10 inches) high. This does not include space for the required computer.

4-1 Start up the dispenser

1. Unpackage the dispenser and remove the four pieces of the shipping bracket.
2. Connect the separately packaged power cord to the rear of the dispenser. See
3. Plug the other end of the power cord into the appropriate power outlet. See
4. Turn the dispenser on using the main power switch adjacent to the power cord connection on
the rear of the Dispenser. Press the ―l‖ on the switch to turn the dispenser on. See
5. The HP logo on the front of the dispenser will illuminate and the pogo block LEDs will flash,
indicating the beginning of the Dispenser initialization routine.
6. Use the USB cable that came with the dispenser to connect the computer to the dispenser.
The USB port is on the rear of the dispenser. See
Figure 4-3
dispenser. Depress ―1‖ to turn on.
7. The first time the Dispenser is connected to the computer, Device Manager will ask you for a
device driver.
Insert the CD that was enclosed with the Dispenser into your computer's disk drive.
8.
9. If your computer does not autorun the installer, use Windows Explorer to locate the setup.exe
file on the CD disk drive.
10. Run setup.exe and follow the on-screen instructions to install both the device driver and the
HP D300 Digital Dispenser software.
The phone number can be found at http://www.tecan.com/customersupport.
On/off switch on rear of
HP D300 Digital Dispenser
Figure 4-4.
Figure 4-4 USB port on rear of
dispenser
Figure 4-3.
―Get
started.‖
Figure 4-3.
11