Table of Contents
Advertisement
Bluetooth Operation
Connecting a Bluetooth Device
4.40
When using the Bluetooth connection, you can listen to audio
wirelessly from a Bluetooth audio device (For example an MP3
player) within 10 metres of the MICRODAB16BT unit.
1. When the Bluetooth mode is selected the words 'NOT
CONNECTED' will flash on the display. This means the unit
is in connection mode and will pair with any previously
connected devices.
2. If you have not connected a device you can now enable
'discovery' mode on your device and select the
MICRODAB16BT Bluetooth connection. If you are asked for
a pass code enter '0000'.
If you turn off either device before pairing is complete the
process will need to be repeated when powered ON again.
3. Once paired a beep will be heard and the display will
change to 'CONNECTED'.
The volume output is effected by the volume level on the audio
source EG: Phone or laptop, so make sure that is set to about
70-80% (not too loud to avoid distortion).
4. To un-pair a device press the 'UNPAIR' button on the
remote control. You can now pair another bluetooth device
to the MICRODAB16BT.
Controlling a Connected Device
4.41
Once connected you can either use the controls on the audio
device to begin playback, skip tracks etc. Or you can use the
control buttons on the unit/remote control.
1. The
button when pressed will begin playback of the
selected track on the audio device. Press again to pause
playback.
2. To skip to the next track press the
3. To skip to the previous track press the
button.
button.
MICRODAB16BT
Advertisement
Table of Contents
