Table of Contents
Advertisement
Operation
Now your CD micro system is installed and
ready for use, please refer to the following
instructions for correct operation.
AC Power Operation
The CD micro system will be in standby mode,
when the AC power supply is connected
and switched on.
At the front of the CD micro system, or using
the remote control, press POWER, to switch
the CD micro system on. The LCD display
will light up.
Volume Control
WARNING
Do not turn off the CD micro system when
the volume is set at high level. When it is
subsequently turned on, a sudden blast of
sound may damage your hearing and the
external speakers.
The volume level can be adjusted either
using the controls on the unit or by the
remote control.
On the unit press the (+) button to increase
the volume and press the (-) to reduce the
volume. The volume level will be displayed
while adjustments are being made.
To adjust the volume level using the remote
control, press the VOLUME +/- buttons.
Press MUTE on either the unit or the remote
control to mute the sound. Press MUTE again
to resume sound.
Note: Pressing any of the volume control
buttons will also resume sound.
Headphones
Note: Reduce the volume to a low level before
putting on headphones. Adjust volume
to a comfortable level.
A headphones socket is provided for private
listening. It is located on the front of the unit.
see page 3
A pair of stereo headphones with a 3.5mm
stereo plug is required. Insert the stereo plug
into the socket for headphone use.
The external speakers are automatically
disconnected when headphones are in use.
T O N E
Your CD micro system has " BASS/TREBLE"
sound effect setting. The setting can be
selected by pressing the TONE button on the
remote control or on the unit.
a.
Press once to Bass mode.
b.
Press again to Treble mode.
c.
Press Vol Up/Down button to adjust the
Bass/Trebel effect.
Advertisement
Table of Contents
