Table of Contents
Advertisement
5
Troubleshooting
Problem
No Power
No sound from the CD
No sound from an AUX input
The sound is distorted
The sound is distorted from an AUX input
Unable to play a CD
Static interference/Burbling sound when
listening to the radio
Bluetooth sound is interrupted or distorted
Remote control not working
What to do
Check the mains plug is connected to the wall socket.
Switch the wall socket on.
Press the STANDBY button to wake from Standby
mode.
The volume level is too low. Increase using the
volume control.
The volume level is too low. Increase using the
volume control.
The external audio source volume is too low,
increase the volume level.
Reduce the MICRODAB16BT volume level using the
volume control.
The external audio source volume is too high,
decrease the volume level.
Check there is a disc present in the CD drawer.
Remove and re-insert the CD with the label side
facing upwards.
Clean the disc, it may be dirty. If scratched try
another disc.
This is caused by poor reception. Re-locate the
antenna or if that fails try moving the
MICRODAB16BT to a different location.
The unit is close to a device that generates
electromagnetic radiation. Re-locate the
MICRODAB16BT away from the electromagnetic
radiation source
Obstacle(s) between the unit and the Bluetooth
audio source device. Remove the obstacle.
Battery is exhausted. Replace the battery.
There is an object blocking the path to the IR
sensor. Remove the object and try again.
Check the battery is installed correctly. Re-fit the
battery if not.
MICRODAB16BT
Advertisement
Table of Contents
