Table of Contents
Advertisement
DAB Radio Operation
Using DAB For the First Time
4.10
1. After switching to DAB input mode for the first time a full
scan of DAB stations is performed automatically.
During the full scan mode, the LCD will display a slide bar that
indicates the progress of the scan, and the amount of radio
stations that have been found so far. Once the scan has
finished, the radio will select the first alphanumeric station.
NOTE: The station name will be shown on the top of the
display. Information about the DAB radio station will be
displayed on the bottom of the display.
2. To listen to the located DAB stations use the
buttons. When you reach the desired station press the
ENTER button to begin playback of that station.
NOTE: If no stations were found, or no DAB stations can be
received currently [No DAB station] will be displayed. In this
case you may need to perform another station scan.
Positioning the Antenna
4.11
Positioning of the aerial will influence the DAB signal quality.
1. To find the optimum position, select the display signal
strength indicator by cycling through the display modes
using the INFO button.
2. Once the indicator is displayed, move the aerial and
observe the signal level as shown by the bar graph. When
you are happy with the positioning, perform an auto-tune to
capture all of the available stations.
Full Scan
4.12
1. To activate the full scan press the MENU button.
2. When you see the <Full scan> option press the ENTER
button. The unit will search for all available DAB stations that
can be tuned.
Scanning...
/
Absolute 80s
14
MICRODAB16BT
Advertisement
Table of Contents
