Quick Setup; Connecting The Speakers - Goodmans MICRODAB16BT User Manual

3

Quick Setup

Fitting the Remote Battery
3.0
1. Press the small tab to the left of the battery insert inwards.
Then slide the battery insert out of the main remote unit.
2. Insert 1 x CR2025 battery into the removable battery slot
taking note that the + polarity faces upwards.
3. Replace the battery insert by simply pushing back into the
space you removed it from.
Leaking batteries may damage the battery cabinet and the
remote as a whole. If you are not going to use the
MICRODAB16BT for an extended period, please remove the
battery to avoid damage.
Caution: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
3.1

Connecting the Speakers

1. Unwrap the speaker wires.
2. Place a speaker on either side of the main unit, preferably at
the same height, and with at least 150mm between each
speaker and the main unit.
RIGHT SPEAKER
3. Connect the speaker wires to the terminals on the rear of
the unit (P). Take care to match the speaker placed to the
LEFT to the LEFT output on the rear of the unit. Repeat for
the RIGHT speaker.
4. When connecting ensure the RED wire connects to the
RED terminal and the BLACK wire to the BLACK terminal.
REAR PANEL
LEFT SPEAKER
MICRODAB16BT