Fm Radio Operation - Goodmans MICRODAB16BT User Manual

FM Radio Operation

Tuning a Station
4.20
1. You can scan up or down the frequency range manually by
pressing the
frequency in 0.05 MHz increments. To scan through the
frequency range quickly press and hold either
buttons.
2. Once a station has been found, the scanning will stop
automatically. If no station is found, then the tuning will stop
once it has cycled through the entire FM band (87.5-
108MHz).
Scan Modes
4.21
When performing an scan you can set the sensitivity level of
the stations to be found. EG: strong signals only or all stations.
1. In FM mode, press the MENU button, when <Scan Setting>
appears on the display press the ENTER button to view the
submenu.
2. Use either
will detect any station, even with a weak signal) or STRONG
STATION (which will only detect stations with a good signal
strength). Press the ENTER button to select the required
option.
3. When you perform a scan as described in 'Tuning a station',
only stations fitting the applied setting will be detected.
4.22 Stereo/ Mono Mode
Sometimes Stereo radio stations can suffer from interference
(static & crackles) to reduce this problem you can enable
MONO mode.
1. In FM mode, press the MENU button. When <Scan
Setting> appears on the display press either
buttons to locate 'Audio setting', then press the ENTER
button to view the submenu.
2. Use the
MONO.
3. Press the ENTER button to save the setting and MENU to
exit.
/ buttons to increase or decrease the
/ buttons to select ALL STATIONS (which
/ buttons to select between STEREO or
/
/
MICRODAB16BT