Enter Cli Mode; Boot Command Syntax; Booting From A Selected Image; Boot Using No Configuration File - Cisco ASR 5500 Administration Manual

System Recovery
aborted by user
8/0:boot>

Enter CLI Mode

With the boot prompt displayed, enter cli to access the boot recovery CLI. The CLI prompt changes as shown
below:
8/0:boot>
8/0:cli>

boot Command Syntax

The boot recovery command has the following syntax:
boot [ -show | -priority=* | -config=* | -noconfig ] { bootfile_URL }
The options for this command include:
• -show: displays the current boot configuration
• -priority=*: selects the desired boot stack priority (*)
• -config=*: enters the desired configuration filename (*), if not the default file
• -noconfig: boots using no configuration file
bootfile_URL is the URL for the location of the StarOS boot image file. It specifies the path and file name
of the StarOS .bin file from which the system will be booted.
The URL may refer to a local file (flash) or an external file on a memory device attached to the management
card. The URL must be entered in the following format:
{ /flash | /pcmcia1 | /usb1 }/filename

Booting from a Selected Image

You will issue a boot command via the boot CLI to initiate the system recovery process.

Boot Using No Configuration FIle

This procedure boots the system using the specified boot image without also loading a configuration file. A
sample command string appears below:
8/0:cli>boot -noconfig /flash/image_filename.bin
The boot sequence ends with a prompt to enter the Quick Setup Wizard for creating a configuration file.
Launching StarOS
Starting program at 0x0000000000100000
Starent Networks ASR5x00 Intelligent Mobile Gateway
management_card
Starting software
No configuration found, press enter to continue.
1. Do you wish to continue with the Quick Setup Wizard[yes/no]:
cli
is starting up..............................
image_version_number
...
ASR 5500 System Administration Guide, StarOS Release 19
Enter CLI Mode
181