Installing Encs-Mraid Drivers For Nfvis; Raid Configuration; Jbod Mode; Raid-1 Mode - Cisco 5400 ENCS Hardware Installation Manual

Enterprise network compute system
Table of Contents

Advertisement

Supported RAID Controllers and Required Cables

Installing ENCS-MRAID Drivers for NFVIS

NFVIS 3.6.1 already includes the required drivers and there is no need to install additional driver for this
RAID controller.

RAID Configuration

RAID configuration is done through CIMC Web GUI unless specified otherwise. Though ENCS-MRAID
controller can support multiple RAID modes, the physical limitation of ENCS chassis (two physical drives)
restrict ENCS-MRAID controller only supporting JBOD and RAID-1 modes under NFVIS 3.6.1.

JBOD Mode

When a brand new drive is inserted, the drive's status is either Unconfigured Good or JBOD. If drive is in
Unconfigured Good status, use the following steps to enable JBOD mode:
Procedure
Command or Action
Step 1
Log into CIMC.
Step 2
choose Storage tab on the left pane.
Step 3
Choose Physical Drive Info tab in middle pane.
Step 4
Highlight the drive which is in Unconfigured Good status.
Step 5
Click Set State as JBOD in the Actions field.
Step 6
Reboot NFVIS to use the new installed drive.
For existing ENCS with external drives inserted but no RAID card installed, the drives will be set to JBOD
mode without further configuration after RAID card installed..

RAID-1 Mode

After both drives are in Unconfigured Good state, use the following steps to create virtual disk (under
WebGUI):
Before you begin
To enable RAID-1 virtual disk on ENCS, refer to Mixing Drives Types in RAID Groups for hard drive
compatibility and best practice for performance. Before creating virtual disk, both drives must be in
Unconfigured Good status. If drive is on other status, use CIMC Web GUI/CLI and do the following:
• If disk is in JBOD state: go to Storage tab > Physical Drive Info tab, choose Set State as Unconfigured
• If disk is in Foreign Config state, go to Storage tab > Controller Info tab, choose Clear Foreign Config
Good link for this drive.
in Action field.
Cisco 5400 Enterprise Network Compute System Hardware Installation Guide

Installing ENCS-MRAID Drivers for NFVIS

Purpose
41

Advertisement

Table of Contents
loading

Table of Contents