Configuring The Service Redundancy Protocol (Srp) Context; Creating And Binding The Srp Context - Cisco ASR 5500 Administration Manual

Interchassis Session Recovery
To configure the ICSR on a primary and/or backup chassis:
Step 1 Configure the SRP context by applying the example configuration in
(SRP) Context, on page
Step 2
Modify the source context of the core network service by applying the example configuration in
Context for ICSR, on page
Step 3 Modify the destination context of core network service by applying the example configuration in
Context for ICSR, on page
Step 4 Optional: Disable bulk statistics collection on the standby system by applying the example configuration in
Bulk Statistics Collection on a Standby System, on page
Step 5
Verify your primary and backup chassis configuration as described in
Configuration, on page
Step 6 Save your configuration as described in Verifying and Saving Your Configuration.

Configuring the Service Redundancy Protocol (SRP) Context

To configure the system to work with ICSR:
Step 1 Create the chassis redundancy context and bind it to the IP address of the primary chassis by applying the example
configuration in
Step 2 Configure the chassis redundancy context with priority, chassis mode, hello interval, dead-interval and peer IP address
by applying the example configuration in
Step 3
Configure the SRP context with interface parameters (including interface name, IP address and port number) for interchassis
communication by applying the example configuration in
286.
Step 4 Verify your SRP context configuration as described in
Step 5 Save your configuration as described in Verifying and Saving Your Configuration.

Creating and Binding the SRP Context

Use the example below to create the SRP context and bind it to primary chassis IP address:
279.
288.
289.
290.
Creating and Binding the SRP Context, on page
Configuring SRP Context Parameters, on page
Configuring the Service Redundancy Protocol (SRP) Context
Configuring the Service Redundancy Protocol
290.
Verifying the Primary and Backup Chassis
279.
Configuring the SRP Context Interface Parameters, on page
Verifying SRP Configuration, on page
ASR 5500 System Administration Guide, StarOS Release 19
Modifying the Source
Modifying the Destination
Disabling
280.
287.
279