Applying An Acl To A Radius-Based Subscriber - Cisco ASR 5500 Administration Manual

Access Control Lists
configure
context_name
context
ip access-list
deny host
deny ip any host
exit
ip access-group
service-redundancy-protocol
exit
interface
ip address
exit
subscriber default
exit
aaa group default
exit
gtpp group default

Applying an ACL to a RADIUS-based Subscriber

IP ACLs are applied to subscribers via attributes in their profile. The subscriber profile could be configured
locally on the system or remotely on a RADIUS server.
To apply an ACL to a RADIUS-based subscriber, use the Filter-Id attribute.
For more details on this attribute, if you are using StarOS 12.3 or an earlier release, refer to the AAA and
GTPP Interface Administration and Reference. If you are using StarOS 14.0 or a later release, refer to the
AAA Interface Administration and Reference.
This section provides information and instructions for applying an ACL to an individual subscriber whose
profile is configured locally on the system.
Important
To configure the system to provide access control list facility to subscribers:
Step 1 Apply the configured access control list by following the example configuration in
Subscriber, on page 194
Step 2 Verify that ACL is applied properly on interface by following the steps in
Individual Subscriber, on page 194
Step 3 Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
save configuration command. For additional information refer to the Verifying and Saving Your Configuration chapter.
acl_name
ip_address
ip_address
access_group_name
interface_name
ip_address/mask
end
This section provides the minimum instruction set for applying the ACL list to all traffic within a context.
For more information on commands that configure additional parameters and options, refer to the Subscriber
Configuration Mode Commands chapter in the Command Line Interface Reference.
Applying an ACL to a RADIUS-based Subscriber
Applying an ACL to an Individual
Verifying the ACL Configuration to an
ASR 5500 System Administration Guide, StarOS Release 19
193