Avaya 8800 Maintenance Manual page 85

2. Wait 10 seconds for the fans to stop turning. Pull the fan tray or cooling module from
3. Slide the new fan tray or cooling module into the chassis until the connectors at the
4. Tighten the captive screws to fasten the fan tray or cooling module to the chassis.
5. With the chassis power on, verify that the green status LED is illuminated.
Routine Maintenance
Replacing the fan tray or cooling module in an 8006 or 8010 chassis
the chassis.
Caution:
Grasp the fan tray or cooling module at the middle of the front panel. Be careful
to keep your fingers away from the fan blades.
rear of the fan tray or cooling module engage.
If the chassis is powered on, the fans start running when the fan tray or cooling
module connectors are fully engaged.
March 2011 85