H3C S7502 Installation Manual
Hide thumbs
Also See for S7502:
- Installation manual (50 pages) ,
- Operation manual (14 pages) ,
- Installation manual (19 pages)
Table of Contents
Advertisement
Quick Links
Installation Manual
H3C S7502 Ethernet Switch
Chapter 6 Hardware Maintenance................................................................................................ 6-1
6.1 Required Tools................................................................................................................... 6-1
6.2 Removing and Installing Power Module ............................................................................ 6-1
6.2.1 Installing a Power Module ....................................................................................... 6-1
6.2.2 Removing a Power Module ..................................................................................... 6-2
6.3 Removing and Installing Cards.......................................................................................... 6-2
6.3.1 Installing a Card ...................................................................................................... 6-3
6.3.2 Removing a Card .................................................................................................... 6-3
6.4 Removing and Installing Fan Tray ..................................................................................... 6-4
6.5 Installing the Mounting Brackets and Cable Management Bracket................................... 6-5
Table of Contents
i
Table of Contents
Advertisement
Table of Contents
Related Manuals for H3C S7502
Summary of Contents for H3C S7502
- Page 1 Installation Manual H3C S7502 Ethernet Switch Table of Contents Table of Contents Chapter 6 Hardware Maintenance....................6-1 6.1 Required Tools........................6-1 6.2 Removing and Installing Power Module ................6-1 6.2.1 Installing a Power Module ..................6-1 6.2.2 Removing a Power Module ..................6-2 6.3 Removing and Installing Cards..................
- Page 2 Chapter 6 Hardware Maintenance Caution: The power modules of the S7502 are hot-swappable. When installing or replacing an in-service power module, pay attention to operations and electrical safety. Do not touch any naked wire, terminal or any part of the product labeled with a high-voltage warning to avoid injury.
- Page 3 6.3 Removing and Installing Cards SRPU and LPUs of the S7502 can be installed and removed in a similar way. This section describes the general procedures for installing and removing these cards.
- Page 4 Installation Manual H3C S7502 Ethernet Switch Chapter 6 Hardware Maintenance Figure 6-2 Install a card 6.3.1 Installing a Card Wear an ESD-preventive wrist strap and loose the captive screws on the blank panel on the slot, where the card should be inserted.
- Page 5 Installation Manual H3C S7502 Ethernet Switch Chapter 6 Hardware Maintenance 6.4 Removing and Installing Fan Tray Caution: Do not touch any naked wire, terminal or any part of the product labeled with a high-voltage warning to avoid bodily injury. Figure 6-3 Install a fan tray Wear an ESD-preventive wrist strap and loose the captive screws on the fan tray.
- Page 6 6.5 Installing the Mounting Brackets and Cable Management Bracket Two mounting brackets and a cable management bracket are shipped with the S7502. Take the following steps to install the mounting brackets and cable management bracket: Face the LPU slots of the switch.
Need help?
Do you have a question about the S7502 and is the answer not in the manual?
Questions and answers