Maintenance Mode - Stairmaster Gauntlet Owner's Manual

MAINTENANCE MODE - LCD
Maintenance Mode allows access to service and diagnostic information, as well as provides the ability to adjust certain
program default parameters. To enter Maintenance Mode:
1. Press and hold the ,
2. A beep will sound and "MAINTENANCE MODE" will display momentarily in the Information Window.
3. Release all keys. "SERIAL NO #####" will display in the Information Window.
The following keys are available in MAINTENANCE MODE:
Increase and Decrease LEVEL Keys: Adjust the value of the displayed parameter up and down, respectively, in
incre- ments of 1 unit. These keys do not save the new value - see OK Key below.
Numeric Keypad: Allows you to enter specific values for numeric parameters. These keys do not save the new
value - see OK Key below.
OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Maintenance Mode.
NOTE: To exit Maintenance Mode without saving any values or settings, press the QUICK START key.
A complete list of the items that you may display and change in Maintenance Mode:
Item
SW VERSION
LCB VERSION
SERIAL #
RUN HRS
MAINT HRS
FLOORS
UNITS (ENGLISH/METRIC)
DEFAULT TIME (5-180)
and keys together.
Min Max
01.00 99.99
01.01 99.99
0 65535
0 65535
0 9999
0 65535
English Metric
5 180
Default Notes
N/A Display software version (set by factory)
Load Control Board software version
N/A
(set by factory)
N/A Serial number (set by factory)
N/A Total operating hours
N/A Total operating hours since last reset
N/A Total floors climbed
English = pounds, feet; Metric = kilograms,
English
meters
120 Default time used by programs
28