3. Troubleshooting
C
A
FLM HD
Image 3-4
Status LED's of the Formatter Interface Board (HD version). Visible trough the grid behind
the front filter.
A
Orange LED "PWRGood" OK.
B
PowerGood status: LED color = Green "High"; Yellow "Low";
Red "Fail".
C
FPGA status: LED color = Green "Normal"; Yellow "Boot"; Red
"Fail".
Error 1693 : "Blue form. start failed"
Situation
No communication with the
formatter board of the blue channel.
The projector fails to start.
FLM
Image 3-5
Formatter board with data cables plugged in. Two data cables for FLM and three data cables for FLM HD per formatter board.
18
B
Solution
•
Check if the data cables between the Formatter Interface Board (FIB) and the
formatter board of the blue channel are plugged in properly.
•
Check if none of the wires came loose from the plugs on the wire unit.
•
Reboot the projector. If the problem remains contact Barco for further instructions.
The formatter board of the blue channel is malfunctioning and has to be replaced
at the factory.
FLM HD
R59770072 FLM SERIES 19/03/2007