Barco FLM series Service Manual page 152

15. Vertical and Horizontal shift motors
F E D D C
Image 15-17
4. Turn the first squared nut C on the axe until the middle of the axe. Then slide both washers D on the axe with the spherical side
towards each other. Continue with the connection piece E (as shown in the drawing) and finally, turn again a squared nut F on
the axe.
Fasten both squared nuts so that there is no play anymore but so that when pulling or pushing on the connection piece, it still
can move up or down.
5. Pivot the assembly back on its place. Make sure that connection piece E matches its socket. If not so, move the assembly on
the axe until it match.
G
H
Image 15-18
Assemble lens holder
6. Insert the big axe G, fasten both screws H and turn in the connection screw I.
7. Guide all cables in the groove, place the cover plate on its place and turn in the 4 screws.
150
A
B
E
H
R59770072 FLM SERIES 19/03/2007