Set Up Ucr 2008 In Common Phone Profile - Cisco 7800 series Administrator's Manual

Phone Feature Configuration

Set Up UCR 2008 in Common Phone Profile

Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
• SSH Access
• 80-bit SRTCP
• Web Access
Procedure
Step 1 In Cisco Unified Communications Manager Administration, choose Device > Device Settings > Common
Phone Profile.
Step 2
Set the FIPS Mode parameter to Enabled.
Step 3 Set the SSH Access parameter to Disabled.
Step 4 Set the Web Access parameter to Disabled.
Step 5 Set the 80-bit SRTCP parameter to Enabled.
Step 6
Select Save.
Set Up UCR 2008 in Enterprise Phone Configuration
Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
• 80-bit SRTCP
• Web Access
Procedure
Step 1 In Cisco Unified Communications Manager Administration, choose System > Enterprise Phone
Configuration.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the 80-bit SRTCP parameter to Enabled.
Step 4 Set the Web Access parameter to Disabled.
Step 5
Select Save.
Set Up UCR 2008 in Phone
Use this procedure to set the following UCR 2008 parameters:
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
154