Front Assist; Overtaking And Towing; Malfunctions - Skoda octavia Owner's Manual

Hide thumbs Also See for octavia:
Table of Contents

Advertisement

Narrow vehicles or vehicles travelling side by side
A narrow or offset vehicle driving can only be recognized by the ACC if this is
located in the scanning range of the
Other vehicles changing lanes
Vehicles that change onto the lane with a small
be detected by ACC in good time.
Stationary vehicles
The ACC does not detect stationary objects! When a vehicle detected by the
ACC turns or sheers off and there is a stationary vehicle in front of this vehicle,
» fig. 162
-  the ACC does not respond to the stationary vehicle.
Vehicles with special load or special body parts
Other vehicles with a load or with body parts protruding from the sides, back
or top of the vehicle contour may not be detected by the ACC.

Overtaking and towing

Read and observe
on page 134 first.
When overtaking
When your vehicle is being controlled at a speed that is lower than the set
speed and the turn signal is operated, ACC assesses this situation as meaning
that the driver wishes to overtake. The ACC automatically accelerates the vehi-
cle, thereby reducing the proximity to a vehicle ahead.
If your vehicle changes to the overtaking lane and no vehicle is detected
ahead, ACC accelerates until the set speed is reached and then keeps it con-
stant.
Acceleration can be cancelled at any time by touch on the brake pedal or
pressing the button  on the control lever
Towing a trailer
When towing, or if another accessory is connected to the trailer socket, ACC
control is set with a lower rate. The manner of driving should therefore be
adapted to this limitation.

Malfunctions

Read and observe
on page 134 first.
If, for some unknown reason, ACC is not available, the warning light appears
in the display of the instrument cluster and an appropriate message is shown.
138
Driving
radar» fig. 161
- .
distance» fig. 162
- may not
» fig. 160
on page 136.
Sensor covered / dirty
If the sensor is dirty or covered, a message indicating that there is no sensor
view appears. Clean the sensor cover or remove the
page 120.
ACC not available
If the ACC is currently unavailable, a message concerning the unavailability ap-
pears. Stop the vehicle, switch off the engine and then start it again. If ACC
continues to be unavailable, seek the assistance of a specialist garage.
ACC fault
With an ACC fault, an error message appears. Seek help from a specialist ga-
rage.

Front Assist

Introduction
This chapter contains information on the following subjects:
Operation
Distance warning
Warning and automatic braking
Deactivation/activation
Malfunctions
Front Assist (from here on referred to only as system) warns you of the danger
of a collision with a vehicle or an obstacle in front of the vehicle and tries to
avoid a collision or mitigate its consequences by automatically applying the
brakes as appropriate.
The area in front of the vehicle is monitored by a radar sensor
WARNING
The general information relating to the use of assistance systems must
be observed
» page 120,
in chapter Introduction.
The system does not respond to crossing or oncoming objects.
CAUTION
In case of failure of more than one brake light on the vehicle or on the electri-
cally connected trailer, the system becomes unavailable.
obstacles» fig. 143
on
139
139
139
140
140
» page
120.

Advertisement

Table of Contents
loading

Table of Contents