Skoda octavia Owner's Manual page 51

The ignition is switched on.

Wi-Fi is switched on in the external device that is to be connected to.

The external device that is to be connected to stores the password re-

quired for the connection check.
Connection to SmartGate using Wi-Fi direct
This type of connection is intended for external devices running the Android
operating system.
Connection set-up
›
Switch on the ignition.
›
In the external device that is to be connected to, start the SmartGate appli-
cation.
›
In the application, change the connection type to Wi-Fi direct.
›
Then follow the instructions which are included in the SmartGate application.
The password for the connection to SmartGate _...
of the vehicle identification number
With SmartGate, a maximum of two external devices can be connected simul-
taneously using Wi-Fi direct, with as many launched ŠKODA applications as re-
quired.
If you want to connect to SmartGate in a different vehicle, you must make a
new connection in the SmartGate application.
Disconnection
The connection can be disconnected in one of the following ways.
›
Switch off the ignition for longer than 5 seconds (for vehicles with the starter
button, switch off the engine and open the driver's door).
›
Terminate the connection on the SmartGate application.
›
Switch off Wi-Fi in the connected external device.
Automatic connection
If the external device once had a connection with SmartGate, then the connec-
tion is automatically restored after the ignition is started.
SmartGate web interface
You can set SmartGate parameters in the SmartGate web interface.
1)
At the position ..., the last 6 symbols of the vehicle identification number are displayed.
2)
If the "Reboot" button is not displayed, then the web browser display must be restored manually.
includes the last six digits
1)
» page 49.
The following address must be entered in the web browser of the external de-
vice that is connected with SmartGate.
HTTP://192.168.123.1
The setting changes are only effective after pressing the buttons "Save" →
"Reboot".
Password/PIN code
The password for the Wi-Fi connection preset by the factory is the complete
vehicle identification number (entered in upper case); the PIN code for the Wi-
Fi direct connection is the last 6 digits of the vehicle identification number.
After changing the password/PIN, the connection to SmartGate must be re-es-
tablished on the external device to be connected using the new password or
new PIN code.
Password change for the Wi-Fi connection
›
Open the SmartGate web interface
›
In the menu item "WPA / WPA2 key:" enter the new password (8 to 63 alpha-
numeric, special, lower and upper case characters).
›
Confirm the password by pressing the "Save" button.
›
Restart SmartGate by tapping on the "Reboot"
PIN code change for the Wi-Fi Direct connection
›
Open the SmartGate web interface
›
In the menu item "Wi-Fi Direct PIN:", enter the new PIN code (6 digits).
›
Confirm the PIN code change by tapping on the "Save" button.
›
Restart SmartGate by tapping on the "Reboot"
Notice
If you have forgotten your password for connecting to SmartGate, SmartGate
must be reset to factory settings in a specialised workshop.
» page 49, SmartGate web interface.
button.
2)
» page 49, SmartGate web interface.
button.
2)
Information system
49