Speedometer - Skoda octavia Owner's Manual

Warning at when the preset speed is exceededallows the setting of a speed
limit where, if exceeded, an acoustic warning signal and a warning message
appears on the display of the instrument cluster.
Traffic sign recognition - traffic signs display
tion.
Current Speed - Digital speedometer.
Average speed - Value constantly recalculated, for distance since last clearing
the memory. After erasing the memory, no data will appear for the first 300 m
driven.
Distance driven - Distance driven since the memory was last cleared.
Driving time - Driving time since last clearing the memory.
Comfort consumers - information about the total consumption of the comfort
consumers in l/h and a list of three consumers (e.g. air conditioning etc.), which
have the largest share of fuel consumption.
Refill amount After the consumption of about 10 litres of fuel from the fully
1)
refuelled tank, an amount of fuel is displayed in l. This amount can now be
safely refilled.
Natural gas qualityThe details of the quality of natural gas are displayed as a
percentage of between 70% to 100%. The higher the value, the lower the con-
sumption of natural gas.
Coolant temperature - If the coolant temperature is in the range 70-120 °C,
the engine operating temperature has been reached. If the temperature is be-
low 70 ° C, high engine speeds and straining the engine should be avoided. If
the temperature is over 120°C, the warning light illuminates in the instru-
ment cluster» page 38.
Warning when exceeding the set speed
The system offers the possibility to set a speed limit beyond which an acoustic
warning signal will sound and the following warning message appears in the
display of the instrument cluster.
Adjust the speed limit while the vehicle is stationary
›
Select the menu item Warning at () or  () and confirm.
›
Set the desired speed limit in 5 km/h steps.
1)
Only valid for some countries.
44
Using the system
» page 145, Road sign recogni-
›
Confirm the set value, or wait several seconds; your settings will be saved
automatically.
Adjusting the speed limit while the vehicle is moving
›
Select the menu item Warning at () or  () and confirm.
›
Drive at the desired speed.
›
Confirm the current speed as the speed limit.
The set speed limit can be manually adjusted later if needed.
Reset speed limit
›
Select the menu item Warning at () or  () and confirm.
›
By confirming the speed stored in the memory, the speed limit is reset.
The speed limit set mode is stored even after the ignition is switched off and
on. After a gap between driving exceeding 2 hours, the pre-set speed limit is
deactivated.
Memory
The system saves the data in the three memories described below which are
displayed at the position » fig.
A
Since start ( ) Or "1 "( )
Driving data is stored from when the ignition is switched on to when it is
switched off. If the trip is continued within 2 hours after switching off the igni-
tion, new data will also flow into the calculation of the current driving informa-
tion.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
Fig. 26
Memory display: MAXI DOT dis-
play () / Segment Display ()
26.
