Skoda octavia Owner's Manual page 186

›
Jack up the vehicle until the wheel that needs changing is clear of the ground
» page 186.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper,
etc.).
›
Remove the wheel carefully.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Tighten the wheel bolts opposite each other using the wheel wrench ("pull-
ing crossways")» page 186.
›
Replace the wheel trim» page 184and
When fitting unidirectional tyres, ensure that the direction of rotation is cor-
rect » page 177.
All bolts must be clean and must turn easily. If screws are corroded and diffi-
cult to move, these must be replaced.
WARNING
Undo the wheel bolts just a little (about one turn), provided the vehicle
■
has not yet been jacked up. Otherwise the wheel could come loose and fall
off – There is a risk of an injury.
Under no circumstances must the bolts be greased or oiled - There is a
■
risk of an accident.
Subsequent steps
After changing the wheel, the following work should be carried out.
›
Stow the replaced wheel in the well under the floor covering of the luggage
compartment and secure with a locking screw.
›
Stow the tool kit in the space provided and secure using the band.
›
Check tyre pressure on the mounted wheel and adjust if necessary and, with
vehicles with tyre pressure monitoring, save the tyre pressure values in the
system » page 148.
›
Have the tightening torque of the wheel bolts checked as soon as possible.
The prescribed tightening torque is 120 Nm.
Replace the damaged wheel or consult a specialist garage about repair op-
tions.
184
Do-it-yourself
caps» page 185.
WARNING
Tightening torque which is too high can damage the threads and this can
result in permanent deformation of the contact surfaces on the rim. Where
tightening torque is too low, the wheels may become loose while driving -
There is a risk of an accident. Therefore drive cautiously and only at a mod-
erate speed until the tightening torque has been checked.
Removing/stowing the emergency or spare wheel
The wheel is located in a well under the floor covering in the boot and is fixed
in place with special bolt » fig.
B
Take out wheel
›
Raise the floor covering in the boot
›
Loosen the retaining belt and take out the box with the tool kit.
›
Remove the safe lock in the direction of arrow
A
›
Unscrew the screw in direction of arrow
B
Store wheel away
›
Place the wheel into the wheel well with the wheel rim pointing downward.
›
Pull the fixing band through the opposite holes in the wheel rim.
›
Screw in nut in the opposite direction to arrow
B
›
Insert safety lock in the opposite direction of the arrow
A
›
Place the box with the tool kit back inside the wheel and secure it with the
tape.
›
Fold back the floor in the luggage compartment.
Full wheel trim
Remove trim
›
Hang the clamps for removing the full wheel trims on the edge of the full
wheel trim.
Fig. 207
Take out the wheel
207.
» page 95.
» fig. 207.
1
and remove the wheel.
2
» fig. 207.
2
.
1
