LogicStudio
The Mixed Signal Setup Dialog
Located under Setup → Mixed Signal on the menu bar, this function shows the Mixed Signal Setup Dialog where
you can specify (in nanoseconds) an analog trigger alignment correction value. This setting can be used to fine‐
tune analog data acquired from the oscilloscope to the data from the digital pod (for example to compensate if a
different length of cross‐trigger cable is used). Positive values shift the analog trigger point later in time and
make the analog data move earlier in time relative to the digital data on the Waveform Display Area. Negative
value behaves inversely.
Help
Help information is accessed under Help on the menu bar.
Access the User Manual to conveniently retrieve this same documentation or click About LogicStudio for the
software version and LeCroy contact information.
Tell LeCroy
Under Help on the menu bar, the Tell LeCroy option is always available for providing your feedback. It creates
and sends an email to LogicStudio support at LeCroy. You can even automatically attach your current setup and
data with your feedback.
27
918291 RevA