LogicStudio
The yellow arrows update to display the logical flow based on your choice. An example of the Advanced tab is
shown here.
S
P
T
ERIAL
ROTOCOL
AB
Use this tab to define triggers on serial decode signals you may have defined for I2C, SPI, or UART protocols. An
2
example of an I
C trigger is shown here.
E
T
XTERNAL
AB
Use this tab to set the logic pod to trigger on an external input signal. A threshold voltage for the signal can be
specified.
Sample Rate
The Sample Rate spinner control is located at the top of the dashboard just to the right of the Setup buttons. It
shows the selected rate of sampling for the digital pod. Use the up/down arrow buttons at the right of the
control to cycle through the higher/lower sample rates available on the device. Changes made on the Sample
Rate take effect on subsequent acquisitions.
25
918291 RevA