The Waveform Display Area
The Waveform Display Area takes up the largest portion of the application display space because it's where
configured signal waveforms are shown.
Navigation
The user can navigate the Waveform Display Area and make various view adjustments using the following
controls:
•
Panning the Timeframe ‐ Left‐click and drag left/right and the waveform display area moves in the
direction you've chosen.
•
Zoom a Specific Region – Hold Control, left‐click, and drag left/right. When the mouse button is
released, your zoom is shown in the waveform display area.
•
Scale the Timeframe (Click‐and‐Drag) ‐ Right‐click and drag left/right to scale the timeframe and view
(zoom in/out) around the center point of the view.
OR
•
Scale the Timeframe (Mousewheel) – You can alternatively scale the timeframe using the mousewheel
by putting your mouse pointer anywhere inside the waveform display area and mousewheeling
up/down (instead of right‐clicking and dragging left/right). Mousewheeling advances in 10% increments.
Note: Along with these navigation tools, you can also double‐click any area on the waveform display area to
automatically center the view at the point of your selection.
918291 RevA
Getting Started Manual
12