PLEASE NOTE THE FOLLOWING:
•
The time difference (and frequency between A and B) is shown on both the Waveform Display Area
and on the Cursor's Tool.
•
When a single cursor (of the pair) is placed, the time and frequency is shown in real‐time based on
mouse position until the second half of the pair is placed (by right‐clicking on the waveform).
•
Placing the mouse over the active cursor pair shows the horizontal click‐and‐drag mouse icon.
When this icon appears, you can horizontally click‐and‐drag a cursor to a new location. The display
values are updated accordingly.
•
Clicking a created cursor in the waveform display automatically selects the cursor pair and enables
the cursor tool.
•
When placing or moving a cursor over any digital signal, the software looks for any nearby edges on
the signal and snaps the cursor to that edge. This allows for easier, precise measurements between
edges. When the cursor is successfully snapped to an edge, the cursor's color changes to match the
signal. Snapping does not occur when the mouse pointer is positioned above or below the
waveform.
•
Cursors that cross Analog or Digital Wave signals also display the value of the signal where it meets
the cursor as follows:
918291 RevA
Getting Started Manual
14