Cisco 7600 Sip-200 Default Dip Switch Settings - Cisco Catalyst 6500 Series Hardware Installation Manual

Chapter 2 Catalyst 6500 Series Switch SIPs and SSCs Overview
Figure 2-4
76 00
-M S C
M O DU
LA R
SE RV
IC ES
1

Cisco 7600 SIP-200 Default DIP Switch Settings

If SW3 and SW10 switches are present on the board, make sure that they are set to the default settings,
as shown in
The switches are set to their defaults during manufacture. However, the switch settings may get
inadvertently changed during handling.
Note If the switches are not set to their default settings, there may be momentary packet drops during OIR of
the board.
Table 2-6
Switch
SW3
SW10
OL-9041-04
SIP DIMM Location
-2 00
CA RD
DIMMs
Table 2-6. See Figure 2-5
7600-SIP-200 Default DIP Settings
Default Position
Up
Down
for the location of the switches.
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
Cisco 7600 SIP-200 Overview
1
2-7