Resetting The Switch To The Factory Default Settings; Finding The Switch Serial Number - Cisco CGS 2520 Hardware Installation Manual

Resetting the Switch to the Factory Default Settings

Resetting the Switch to the Factory Default Settings
Follow these steps to return your switch to the factory default settings.
Resetting the switch deletes the configuration and reboots the switch.
Note
To reset the switch:
1.
2.
The switch displays the prompt to run the initial configuration dialog. See the
with the CLI Setup Program" section on page C-1

Finding the Switch Serial Number

If you contact Cisco Technical Assistance, you need to know the switch serial number.
Figure 4-2
command to see the switch serial number.
Figure 4-1
C i sco C
onn ect ed
G ri d
Sw i tch
250 0 Ser
i es
Figure 4-2
Cisco CGS 2520 Hardware Installation Guide
4-6
At the switch prompt, enter enable, and press Return or Enter.
At the Privileged EXEC prompt,
show the serial number locations. You can also use the show version privileged EXEC
Serial Number Location for Cisco CGS-2520-24TC and CGS-2520-16S-8PC Switches
SN: XXXNNNNXXXX
Serial Number Location for the Power Supply Modules
#, enter setup and press Return or Enter.
switch
Chapter 4 Troubleshooting
"Configuring the Switch
Figure 4-1 and
SN: XXXNNNNXXXX
OL-31444-01