2-Port Gigabit Ethernet Spa (Version 2) Leds; 2-Port Fast Ethernet Spa Cables, Connectors, And Pinouts - Cisco Catalyst 6500 Series Hardware Installation Manual

Chapter 3 Catalyst 6500 Series Switch SPA Overview

2-Port Gigabit Ethernet SPA (Version 2) LEDs

The 2-Port Gigabit Ethernet SPA (Version 2) has two types of LEDs: an A/L LED for each port (SFP and
RJ45) and a STATUS LED, as shown in
Figure 3-38
1
Table 3-25
Table 3-25
LED Label
A/L
STATUS
The valid configuration of the SFP and RJ45 ports for the 2-Port Gigabit Ethernet SPA (Version 2) are
as follows:
•
•
•
•
or any single port

2-Port Fast Ethernet SPA Cables, Connectors, and Pinouts

The interface connectors on the 2-Port Fast Ethernet SPA are two individual RJ-45 receptacles. You can
use both the interface connectors simultaneously. Each connection supports IEEE 802.3 and Ethernet
10/100BASE-T interfaces compliant with appropriate standards. Cisco Systems does not supply
Category 5 unshielded twisted pair (UTP) RJ-45 cables; these cables are available commercially. The
RJ-45 connectors are shown in
OL-9041-04
2-Port Gigabit Ethernet SPA (Version 2) Faceplate
A/L (Active/Link) LED
describes the 2-Port Gigabit Ethernet SPA (Version 2) LEDs.
2-Port Gigabit Ethernet SPA (Version 2) LEDs
Color
Off
Green
Amber
Off
Green
Amber
Port 0 (SFP) and Port 1 (SFP)
Port 0 (SFP) and Port 1 (RJ45)
Port 0 (RJ45) and Port 1 (SFP)
Port 0 (RJ45) and Port 1 (RJ45)
Figure 3-38.
1
2 STATUS LED
State Meaning
Off Port is not enabled.
Port is enabled by software and the link is up.
On
Port is enabled by software and the link is down.
On
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and the SPA is being configured.
Figure 3-39.
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
2-Port Gigabit Ethernet SPA Overview
SPA-2X1GE-V2
2
3-45