2-Port Oc48-Pos/Rpr Spa Leds - Cisco Catalyst 6500 Series Hardware Installation Manual

2-Port OC-48 POS/RPR SPA Overview

2-Port OC48-POS/RPR SPA LEDs

The 2-Port OC48-POS/RPR SPA has five LEDs, as shown in
Figure 3-20
1
2
3
Table 3-15
Table 3-15
LED Label
PTH
CAR
PRT
ACT
STATUS
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
3-26
2-Port OC48-POS/RPR SPA Faceplate
1 2
3 4
PTH (Pass-Through) LED
PRT (Protect) LED
CAR (Carrier/Alarm) LED
describes the 2-Port OC48-POS/RPR SPA LEDs.
2-Port OC48-POS/RPR SPA LEDs
Color
Off
Amber
Off
Green
Amber
Amber
Off
Green
Green
Amber
Amber
Off
Green
Amber
Off
Green
Amber
Chapter 3
4 ACT (Active Loopback) LED
5 STATUS LED
State Meaning
Off Port is not in pass-through mode.
Port is in pass-through mode.
On
Off Port is not enabled by software.
Port is enabled by software, and there is a valid
On
SONET signal without any alarms.
Port is enabled by software, and there is at least
On
one alarm.
Blinking Port is enabled by software, and there is a side
mismatch.
Off Port is not in wrap mode or steer.
On A node on the ring is wrapped.
Blinking A node on the ring is steering pass-through
On Port is locally wrapped
Blinking Port is locally steering
Off Port is not enabled by software.
On Port is enabled by software, loopback is off.
On Port is enabled by software, loopback is on.
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and good, and SPA is being
configured.
Catalyst 6500 Series Switch SPA Overview
Figure 3-20.
SPA-2XOC48-POS/RPR
5
OL-9041-04