Add Cleaning Solution - 3D Systems ZPrinter 850 Quick Start Manual

8.3 Add Cleaning Solution

If there is not enough cleaning solution, ZPrint displays
CLEANING SOLUTION in the Printer Status dialog.
Important: Do not add cleaning solution unless you are
prompted to in the ZPrint Printer Status dialog.
To add cleaning solution, follow the steps below.
1. Open the lower door (under the Build Chamber).
2. Pull the empty cleaning solution cartridge out of its housing
on the printer.
3. Get a new cleaning solution cartridge. Check the label for
the expiration date, and for the correct orientation.
4. Insert the cartridge
into its housing.
Ensure the car-
tridge is pushed all
the way in. You
should feel it gently
snap into place.
Important: If a cartridge does not snap into place, do not
force it. Check the orientation and that it is the correct type
and try again.
3dscentral.3dsystems.com
8.4 Replace the Waste Tray
ADD If the Waste Tray is Full, ZPrint displays
the Printer Status dialog.
To replace the Waste Tray, follow the steps below.
1. Open the lower door (under the Build Chamber).
EMPTY WASTE TRAY in
2.Pull the full
Waste Tray out of
its compartment
on the printer.
3.Insert a new
Waste Tray into its
compartment.
Ensure the Tray is
pushed all the way
in.
25