Table of Contents
Advertisement
7.4 Post-Processing Using the Drizzle Method
Parts with delicate features may be damaged by the handling
required for the dipping method. In these cases, apply Z-Bond
using the small bottle and its spout. Be sure the part is dry
and completely free of loose powder before infiltrating.
1.
Place wax paper where you will be working.
2.
Drizzle Z-Bond onto the part. Start with the most delicate
areas first. Wet as much of the part as you can easily reach.
3.
Reposition the part and repeat this process until the entire
part is infiltrated.
4.
Quickly and thoroughly wipe any excess liquid off the part
with paper towels and place the part on the wax paper.
•
Do not let excess liquid pool on the part as this may
cause its texture to change.
22
•
Move the part frequently for the first few minutes. This
prevents pooling of Z-Bond under the part and the part
adhering to the paper.
5.
Let the part dry and cool at least 30 minutes before han-
dling.
3dscentral.3dsystems.com
Advertisement
Table of Contents
